Fastest lead times in Texas  •  UL 891 / UL 1558 assemblies  •  Free delivery planning in 3–5 days Call (951) 403-5738
Home / Resources / When to Repair and When to Replace a Lineup
Blog

When to Repair and When to Replace a Lineup

Parts availability, fault rating and enclosure condition answer the question.

When to Repair and When to Replace a Lineup

The short answer

Parts availability, fault rating and enclosure condition answer the question. In practice, the answer usually comes down to three numbers: the amperage your service carries, the voltage class your utility delivers, and the fault current available at that point. Once those are fixed, the equipment selection follows.

Why it matters

Switchgear is not a commodity box. The bus bracing, breaker frame and enclosure rating are chosen for a specific fault level and a specific room. When any one of those assumptions changes — a larger transformer, a added feeder, a different utility configuration — the equipment has to be re-checked, not just re-priced.

That is also why two quotes for the "same" 2000A lineup can differ by tens of thousands of dollars. One is braced at 65kA with insulated case breakers. The other is braced at 100kA with low-voltage power breakers, drawout compartments and a full relay package.

How to apply it on your project

  • Start from the utility letter: service voltage, amperage and available fault current.
  • Confirm whether the system is grounded wye or delta — it changes the pole count and the neutral.
  • Decide indoor or outdoor, because the enclosure rating drives the layout.
  • Check the room: section width, door swing, cable entry and working clearance.
  • Get the approval drawing reviewed by the installing electrician before fabrication.

Common mistakes

The three we see most often: quoting from an old single-line that no longer matches the service, forgetting utility metering in the section count, and assuming a standard lead time during a busy construction cycle. Each one costs a week or more if it surfaces after the drawings are approved.

Need a number for your project? Send the single-line to saleselectricalbuyers@gmail.com or call (951) 403-5738. We reply with pricing, lead time and a drawing schedule.

Related reading

Request a quote

Request a switchgear quote

Send your single-line or tell us the service size. We reply with pricing, lead time and a drawing schedule.

Call: (951) 403-5738
Email: saleselectricalbuyers@gmail.com

Or call (951) 403-5738
Request a Quote Call (951) 403-5738